| Most viewed - Stand # 16 |
|
|
It wraps around from behind and fits snug around her ribs under her boobs134 viewsLemminkainen
|
|
had to draw it up tighter to stand taller132 viewsLemminkainen
|
|
Before, she used to be wrapped up with para cord all the way around. It looked really bad in photos.131 viewsLemminkainen
|
|
|
CS 2 - caliper stand for large or full-sized lightweight dolls94 viewsLemminkainen
|
|
thin tripod legs and low profile for better 'hiding'91 viewsLemminkainen
|
|
|
aluminum bar, 3/4 inch dowel, hose clamps, and rubber feet82 viewsLemminkainen
|
|
Original telescope tripod with para cord79 viewsLemminkainen
|
|
|
|
|
I think I'm going to drill a hole through the aluminum caliper bars right where all the para cord is binding it in between the 2 Armature fittings and put either a screw/bolt or perhaps just a wire with cotter pins securing either side76 viewsLemminkainen
|
|
|
|
|
|
Kitsune earrings, red bow and silver butterfly hair clip71 viewsLemminkainen
|
|
two segments of paracord for top and center68 viewsLemminkainen
|
|
Exact example of what I found online for dolls and action figures from 2 to 3 inches tall up to 48 inches tall66 viewsLemminkainen
|
|
|
|
|
