| Last additions - Penelope's Hip Repair |
Close up of final repair.1515 viewsmahtekNov 13, 2007
|
|
Next to last adhesive application.679 viewsmahtekNov 13, 2007
|
|
Well, what do you think? Am I still sexy?3390 viewsmahtekNov 13, 2007
|
|
Hip and thigh bolted together. Initial silicone adhesive applied.1068 viewsmahtekNov 10, 2007
|
|
Electrical tape holding the seam closed and aligned.716 viewsmahtekNov 10, 2007
|
|
Tools needed to get at the back joint from the side.629 viewsmahtekNov 10, 2007
|
|
Loosening the back joint.790 viewsmahtekNov 10, 2007
|
|
Detail of the glue grooves and set screw holes in the joint body and pivot.583 viewsmahtekNov 10, 2007
|
|
Close up of joint with set screw alignment marks.611 viewsmahtekNov 10, 2007
|
|
Joint in place.741 viewsmahtekNov 10, 2007
|
|
Set screws aligned and tightened.838 viewsmahtekNov 10, 2007
|
|
Checking if the joint is set at the proper depth.748 viewsmahtekNov 10, 2007
|
|
Injecting the epoxy.763 viewsmahtekNov 10, 2007
|
|
Hip joint attached to the pelvic bracket with the four screws.751 viewsmahtekNov 10, 2007
|
|
Post Op. I'll leave the spreaders in for an hour or so to vent any fumes from the epoxy.2643 viewsmahtekNov 10, 2007
|
|
The proper placement of the thin bearing, and why the retaining plates won't work.593 viewsmahtekNov 08, 2007
|
|
The spine joint can be accessed from the side.783 viewsmahtekNov 05, 2007
|
|
Penelope, preped for surgery.946 viewsmahtekNov 04, 2007
|
|
Penelope's thigh, open at the seam.1048 viewsmahtekNov 04, 2007
|
|
Close up of joint failure. Notice how the pivot shaft is sliding out of the joint body.854 viewsmahtekNov 04, 2007
|
|
Penelope's thigh and pelvis after joint removal.752 viewsmahtekNov 04, 2007
|
|
The disassembled joint and all the tools used so far. The wrenches are 7/16 inch. Abyss uses this size throughout the doll.740 viewsmahtekNov 04, 2007
|
|
|
|
|
|
|
